TMC 2011 Ejector Drill Bit – For Precise Installation

The TMC 2011 Ejector Drill Bit solves the problem of properly fitting a new ejector.

Fitting a new ejector in a 1911 or 2011 can take time and patience. Most of that time goes into marking and filing the groove in the front ejector leg so the pin will seat correctly.

However, this process is easy to get wrong.

If the groove is cut too deep or in the wrong place, the ejector can move up and down. As a result, reliability suffers. In some cases, the ejector may loosen over time.

.

---

A Smarter Way to Fit an Ejector

Instead of marking and filing by hand, this drill bit allows you to drill the pin relief cleanly and precisely. Because the hole is placed exactly where it belongs, the ejector seats correctly the first time.

As a result, the ejector stays tight and secure. At the same time, you avoid trial-and-error fitting.

This method saves time and produces more consistent results.

---

Why a Left‑Hand Drill Bit Matters

This drill bit uses a left‑hand cutting direction, which is critical for proper ejector fitting.

When drilling, the left‑hand cut pulls the ejector leg downward into the frame. Because of this, the ejector stays fully seated while the hole is drilled.

In contrast, a standard right‑hand twist drill pushes the ejector up and away from the frame. That movement leads to poor pin alignment and a loose fit.

Therefore, using the correct drill bit makes all the difference.

---

Designed for Precision and Control

The TMC drill bit is made from high‑speed steel (HSS). This material cuts cleanly and holds its edge well.

Because of its precise size, it creates a clean, accurate hole without chatter. As a result, the ejector pin fits properly and locks the ejector in place.

This makes the tool ideal for both professional gunsmiths and serious home builders.

---

Key Features & Benefits

✔ Left‑Hand Cut Design
Pulls the ejector down into the frame during drilling.

✔ Eliminates Hand Filing
Removes guesswork from marking and cutting the ejector groove.

✔ Improves Ejector Fit
Prevents vertical movement and loose installation.

✔ High‑Speed Steel Construction
Durable, sharp, and built for repeated use.

✔ Saves Time
Speeds up ejector fitting on 1911 and 2011 pistols.

---

Specifications

• Tool Type: Ejector Pin Drill Bit

• Size: 0.09375

• Material: High‑Speed Steel (HSS)

• Cut Direction: Left‑Hand

• Application: 2011 ejector fitting

---

A Small Tool That Makes a Big Difference

Ejector fitting does not have to be slow or risky. With the TMC 2011 Ejector Pin Drill Bit, you get a cleaner fit, better alignment, and more reliable results.

In short, this tool turns a frustrating task into a controlled, repeatable process—exactly what precision pistol work demands.